The ENAiKOON buzzer is a low cost piezo buzzer for signaling and confirming events with a beep.

The buzzer is ideal for confirming iButton bookings while recording working hours.

Especially in working areas with a high noise level, eg. on construction sites or in machines with a loud engine, the buzzer ensures that the audio signal can be heard easily.

The ENAiKOON buzzer can be configured to provide acoustic signal if one of the following events occurs:

• Exceeded speed
• Reading of an ENAiKOON iButton
• Arriving at or leaving a named position (geofence)
• Exceeding of threshold values (e.g. exceeding the maximum temperature during a transport which is part of a cold chain)

The ENAiKOON buzzer is suitable for a variety of applications in combination with ENAiKOON locate onboard units.

Sample application:
The ENAiKOON buzzer is active after the ignition was switched on until the driver of the vehicle attaches his iButton to the ENAiKOON driver-id reader mounted in the vehicle.
This ensures, that the driver does not forget to register himself with the vehicle at the beginning of a shift.

The ENAiKOON buzzer is 100% compatible with the ENAiKOON M2M-commserver.

• ENAiKOON driver-id
• ENAiKOON rfid-tag
• ENAiKOON antenna
• ENAiKOON bag
• ENAiKOON camera
• ENAiKOON display
• ENAiKOON radio-switch
• ENAiKOON buzzer
• ENAiKOON temp-sensor
• Garmin nüvi